IGBT DC dimmer, DC dimmer for battery charging lighting. PWM DC Dimmer 12v-40v DC motor governor switch PWM for speed control, Mini LED 10A PWM Motor Speed Control Dimming Switch.
PWM DC Motor Speed Control Switch Governor 12V-40V 10A
10A Mini PWM LED dimming speed is controlled by Switch
Working Voltage: DC 12V 24V, 36V and 40V
This dimmer can be application for constant voltage driver LED lighting, it adopted the most advanced PWM (pulse-width-modulation) digital brightness-adjusting technology that enables you adjust the brightness with the infinite knob. It could be capable of meeting different demands for brightness at various times by using the dimming. Also, it can extend the life of the LED and cut down on power consumption. It is ideal for dimming high-power or light bulbs with low power.
The DC Motor Speed Controller with a fuse 10A and a Power-On LED light, which controls the speed of a DC motor by adjusting Pulse-Width-Modulated (PWM).
This Dimmer is using 50V/1000uF Capacitor and IGBT IRF3205
Operating voltage DC 12v ~ 40V
Maximum current: 10A. Most efficient operation is below 8A.
Control Power: base on voltage 10% - 100%.
Static Current/Quiescent Current 0.02A(standby)
PWM dimming range is from 10 percent to 100 percent, Note that Due to the large Capacitor to control motors, the PWM variable of dimming could range between 30 percent and 100 percent in the case of the constant voltage of driver LED lights.
PWM frequency 13KHZ
Be safe even should the terminals for the negative and positive of the DC power supply reverse
Size: 60*55*28mm? Mount Holes: 3.2mm, 5mm from the hole in the mount to the outside
Instructions to operate:
1.Before you try to join the controller be sure you have the controller's power off.
2.Please ensure that all connections have been checked before you apply power. This could cause damage when you connect the voltage of the source in the wrong side.
3.Turn off your motor, and afterwards modify your potentiometer.The LED will show the level of power and the speed of the motor.
4.You can set the speed at which the motor is running with the help of a potentiometer.
1.Please not connect to your AC (for instance: your at home, 220V AC ),otherwise it could be burned!
2.The terminals for the negative and positive terminals in the DC power supply can't be reversed.
3.Turn off the power source prior to making any wire modifications.
4.We recommend you to add an appropriate fuse rated the positive supply to avoid any harm from happening.