IGBT DC dimmer, DC dimmer for battery charging lighting. PWM DC Dimmer 10v-60v DC motor regulator switch PWM to control speed mini LED 10A Motor Speed Dimming Control Switch.
PWM DC Motor Speed Control Switch Governor 10V-60V 10A
Dimming of 10A mini PWM LED speed can be controlled by the Switch
Operating Voltage DC10V 12V, 24V 36V 48V 60V
This dimmer can be application for constant voltage driver LED lighting, it adopted the most advanced PWM (pulse-width-modulation) digital brightness-adjusting technology that enables you adjust the brightness with the infinite knob. It may be capable of satisfying different requirements for brightness at different time periods by using dimming. It can also prolong the life of the LED while cutting down on the power consumption. It is perfect for dimming high-power or light bulbs that have low power.
The DC Motor Speed Controller with a fuse 10A and a Power-On LED light, which controls the speed of a DC motor by adjusting Pulse-Width-Modulated (PWM).
This Dimmer uses a 80V/1000uF Capacitor and IGBT
Operating voltage DC 12v ~ 60V
Maximum current: 10A. The most efficient operation is below 8A.
Control Power: base on voltage 0% - 100%.
Static Current/Quiescent Present 0.02A(standby)
The PWM dimming ranges from 0%t up to 100%t. Note that Due to the large Capacitor to control motors, the PWM variable of dimming could range between 20 percent and 100 percent in the case of the constant voltage of driver LED lights.
PWM frequency 21KHZ
Be secure even if you find that the connections for both the positive and negative components of your DC power supply flip
Instructions for operating:
1.Before you attempt to join the controller , make certain that you have the controller's power turned off.
2.Please be sure that all connections are examined prior to applying power. It could result in damage if you connect the source's voltage on the wrong place.
3.Turn off the motor and then alter the potentiometer.The LED will indicate the amount of power used as well as the speed of the motor.
4.You can control the speed at the speed at which the motor runs using an accelerometer.
1.Please do not connect your AC (for example: you are at home with 220V AC ),otherwise it may be burnt!
2.The terminals of positive and negative terminals of the DC power supply are not able to be reversed.
3.Turn off your power source before making any wire changes.
4.We suggest you add an appropriate fuse with a positive to prevent any harm from occurring.