Who's Online

There currently are 61 guests online.

ETL listed 5 CCT 36W dimmable LED bulb 2D fluorescent retrofit

  • Shipping Weight: 0.5 lbs

(image for) Ask a Question


Qty Discounts Off Price
Min:  50
Add to Cart:

36W 5 color temperature bulb, ETL FCC Certificated SCR phase dimming LED bulb suitable of Dimmable Osram Philips Fluorescent bulbs. Five colors of CCT are chooseable. You can select the temperature you wish to use by turning on the light switch, prior to mounting the lighting. Replace 2D fluorescent tube with LED bulb, Retrofit fluorescent LED, 2D retrofit LED and 2-D LED replacements. 2G11 2d 4-pin led replacement, 2d 2-pin LED replacement. 2d 4-pin led replacement, 2 pin 2 pin replacement led. AC120V Triac dimmable LED bulb 36W 2G11 LED 2G10 tube led with 75 Watt CFL replacement. Retrofit fluorescent LED, 2D retrofit led , and two-dimensional fluorescent replacements.

2G10 LED bulbs with four pins on the standard base. Plugs directly into fluorescent receptacles with prongs. It does not use ballasts that are energy-consuming. It's estimated to have 55 % Energy Savings, No fluorescent paint or gas pollution on the premises. Green Light Source, Bypass costly ballasts, and Wire Direct. What is the best way to make the most of U-Shape LEDs and LED T5 fluorescent tube LED replacementHow do I find the most efficient method to use LED bulbs to replace small fluorescent bulbs?.

1.) LED Chip Making Use of Osram led chip

2) Dimension: 155mm x 155mm x15mm

3)Input Voltage: AC120V 60Hz

4) Luminous flux: >3600LM, Ra>80

5.) The Life Time Hrs are 30k.

6.) Color temperature: 2700k 3000k. 3800k. 4400k 5500k temperature selection Select the color temperature you want to use from five by flipping an on before you install your lighting

7.) Power: 28~36 Watt

8.) The socket: connect wire to 2G11 2G10 or another

9.) The dimming bulb is replacing Osram and Phillips Phase dimming fluorescents 75W

It is simple to connect and also to remove/remove your ballast. Make sure you carefully look over your bulb's dimensions in order to make sure that the voltage and power are compatible prior to accepting an offer. Ballasts need to be removed or removed prior to installing an LED light bulb. If you have an existing ballast connected on the light fixture it's important to remove it prior to installing your LED bulb.Otherwise the bulb is more likely to flash.


Your IP Address is:
Copyright © 2023 Powered by Zen Cart