18W 5 color temperature bulb, ETL FCC Certified SCR dimming LED bulb compatible with Dimmable Osram Philips Fluorescent bulbs. Five CCT colors are available for you to choose. You can choose the temperature you would like for by switching off the light switch before mounting the light. Replace 2D fluorescent tube with LED bulb, Retrofit fluorescent LED, 2-D retrofit LED, and 2D LED replacements. 2G11 2d 4-pin led replacement, 2d 2-pin LED replacement. 2d 4-pin led replacement, 2 pin LED replacement. AC120V Triac dimmable LED bulb 18W 2G11 2G10 LED 2G10 tube LED with 36W CFL replacement. Retrofit fluorescent LED, 2D retrofit led, and two-dimensional fluorescent replacements.
2G10 LED bulbs that have four pins in the base. Connects directly to fluorescent receptacles using prongs. It doesn't use ballasts that use energy. It's estimated to provide 55 percent Energy Savings, No fluorescent paint or gas pollutants within the building. Green Light Source, Bypass expensive ballasts or Wire Direct. How do I find the most efficient method to get the most of LEDs with U-Shapes as well as LED T5 fluorescent tube replacement. What can I do to discover the most effective method to utilize the LED bulb to substitute for bulb fluorescents?.
1.) LED Chip Utilizing Osram led chip
2) Dimension: 70mm x 105mm x15mm
3)Input Voltage: AC120V 60Hz
4) Luminous flux: >1800LM, Ra>80
5.) The Life Time Hrs are set at 30k.
6.) Color temperature 2700k 3000k. 3800k. 4400k, 5500k temperature choice Select the temperature of color you wish to select from five by turning on the light before installing your lighting
7.) Power: 16~18 Watt
8.) The socket: connect wire to 2G11 2G10 or another
9.) The dimming bulb replaces Osram along with Phillips Phase dimming fluorescents 36W
It's easy to connect and to remove and replace the ballast. Make sure you carefully examine the dimensions of your bulb to verify that the power and voltage are compatible before taking an offer. Ballasts must remove or be taken away prior installing bulbs with LEDs. If you already have a ballast that is connected to the light fixture, it is essential to take it off prior to installing the LED bulb.Otherwise the light bulb will be most likely to blink.