12W five color temperature lamp, Switching change color temperature 2700K-3000k-3800K-4400k-5000k. ETL FCC Certificated SCR phase dimming LED bulb compatible with dimmable Osram Philips Fluorescent bulbs. CCT comes in five colors that can be selected. You can choose the temperature you want to apply by turning off the light switch before mounting the light. Replace 2D fluorescent tube with LED bulb, Retrofit fluorescent LED, 2-D retrofit LED, and 2D LED replacements. 28w 2d fitting LED replacement 2G11 2d 4-pin led replacement, 2d 2-pin LED replacement. 2d 4-pin led replacement, 2 pin LED replacement. AC120V Triac dimmable LED bulb 30W 2G11 2G10 LED 2G10 tube light bulb with 25W CFL replacement. Retrofit fluorescent LED, 2D retrofit leds , and two-dimensional fluorescent replacements.
Dimmer compatibility test
Test Condition: Vi: AC110-120V 50/60HZ Pi:15W@120V PF>0.9, flicker less than 10%
compatiable below list dimmer:
2G10 LED bulbs that have four pins that fit on the standard base. Connects directly to fluorescent receptacles using prongs. It does not require ballasts that consume energy. It's estimated to provide 55 percent Energy Savings, No fluorescent paint or gas emissions in the facility. Green Light Source, Bypass expensive ballasts as well as Wire Direct. Which is the most efficient method to maximize the use of LEDs with U-Shapes as well as LED T5 fluorescent tubes?. How can I discover the most effective method to utilize the LED bulb to substitute for light bulbs?.
1.) LED Chip Utilizing Osram led chip
2) Dimension: 70mm x 105mm x15mm
3)Input Voltage: AC120V 60Hz
4) Luminous flux: >1200LM, Ra>80
5.) The Life Time Hrs are set at 30k.
6.) Color temperature 2700k 3000k. 3800k. 4400k and 5500k temperature choices Select the temperature of color you wish to choose from five by turning the switch on prior to installing your lighting
7.) Power: 26~30 Watt
8.) The socket: wire connected to 2G11 2G10 or another
9.) The dimming bulb replaces Osram as well as Phillips Phase dimming fluorescents 60W
It is easy to connect and to take off or remove the ballast. Make sure you carefully examine the dimensions of your bulb to ensure that the power and voltage are compatible before accepting an offer. Ballasts should be removed removed prior to the installation of an LED bulb. If you already have a ballast that is connected to the light fixture, it is essential to take it off prior to installing the LED bulb.Otherwise the light bulb is most likely to flicker.